Electronic Balance for Textile Laboratory Precision Weighing

Warning and Safety use Instruction

Safety

● To avoid damage of the balance , please read the operation manual carefully before use .

☆ Please do not use it in dangerous environment .

☆ Please cut off the electricity without use for more than one week .

☆ Please power off the balance when it connects with output device or before cut off the connection .

☆ Magnet or static interference will affect the accuracy of balance , when these interference removed, balance will recover to normal use .

Spare Parts

※ The spare parts we used are the most compatible with the balance .

Any revision to the balance or use the third party’s cable and other device , it’s end user’s responsibility to check and correct the power and voltage .

※ Please do not open the out case , if the safety label is damaged , no warranty will be offered .

         Overview

These series electronic balance was designed and developed by our company. Utilized the advanced microcomputer controlled technology and high precision sensor technology (magnetic balance) , it is the ideal device for fast accurate weighing , widely used in medical research institute schools ,enterprise ,road construction and defense department etc.

▶ LCD backlight display, easy and clear ;

▶ Operator-friendly ,direct weigh ,directly read the weighing result ; 

▶ Highly smart , tare and back to zero within the whole weighing scope , overload display .

▶ Multi-mode choice : counting ,percentage weigh ,density weigh .

▶ With RS-232C interface, easy to connect with printer,computer and other output device .

Part I: Open the package

☆ Once open the package , please check any visible damage on the balance .

☆ Please keep all the packing material until successful installation , to avoid any balance return . When pack the balance , please remove all the cables to avoid any unnecessary damage .

Part II,Packing list

----balance

----operation manual

----scale

----power adapter

----weights(≤500g)

----Conformity certificate

----warranty card

Part III,Remarks

² Forbid to get wet in the rain or washed by water ;

² Forbid to put balance in the place where is too hot or too wet , with vibration ,corrosion ,strong magnet or with the risk of explosion;

² Cockroach and other little creature are forbidden to live inside balance;

² Forbid to be bumped or heavily pressed (not over the max capacity),when use the pan forbidden to be dashed ;

² If the balance not used for a long time , please clean it up ,pack it by plastic bag with drier in ;

² Please pre-heat for 60 minutes before balance was used to raise the precision .

Part IV. Preparation before Use

Put the balance in a level position before use. Use the level adjust feet under the front place to adjust the level until the bubble move to the center of the circle.

Put the balance on the stable and flat table , not on the shaking or vibrating plate , to make the balance stable . (Recommend to use aseismic marble)

Avoid to put balance in the place with big temperature change or air flow , such as the place with direct sunlight or cold air outlet .

Please use the separate power socket to avoid the interruption by other device .

Please do not put anything on the scale when power on the balance.

※ Make balance adjust itself to the change of temperature

When change the balance from lower temperature to higher temperature or reverse , please put the balance in the new environment for about 2 hours , then pre-heat the balance , make it conform with the new temperature.